HobbyWireless
3D WOBBLY ADAPTER - 1.5 MM - PROPSAVER
Details:, , Description:, NEW! 3D Wobbly ADAPTER - PROPSAVER For GWS and APC SLOWFLYER props - fits 1.5 mm shafts - 1 O-RING included - Great for the Feigao Brushless Motors,
HobbyWireless
HITEC HS-56HB KARBONITE GEAR FEATHER SERVO
Details:, , :, , Motor Type:, 3 Pole, Bearing Type:, Top Ball Bearing, Speed:, 0.12 / 0.10 sec @ 60 deg., Torque:, 13.88 / 16.66 oz.in (4.8v/6v), Size:, 0.88" x 0.45" x 0.94", Weight:, 0.37oz,
Description The HS-56HB Feather Servo is the perfect choice for ...HobbyWireless
SANDISK 16GB MICROSD SDHC CLASS 4 MEMORY CARD + SD ADAPTER
| SanDisk MicroSD has great performance and capacity to the SD card family | microSD High Capacity (microSDHC) 16GB flash card. |
| Speed performance rating | Class 4 (based on SD 4.00 Specification) |
Details:, Model:, , Brand :, , Type :, , Speed :, , Capacity :, , Size:,
High storage capacity (16GB) for storing essential digital content such ...HobbyWireless
T1012 TRANSMITTER 1.2 GHZ 1000MW - LAWMATE - ALSO AVAILABLE TO USA CUSTOMERS
| Weight | 30g (transmitter only) |
| Transmission power 50-ohm load CH1 Vcc = 12V | 30dBm |
| Nominal output impedance | 50 ohms |
| Operating voltage | Vcc, 10.5V (minimum), 12V (typical), 13V (maximum) |
| Supply current Vcc = 12V | 450mA (typical), 500mA (maximum) |
| Video input voltage 75-ohm impedance | 1Vp-p |
| Audio input voltage 10k ohm impedance | 1Vp-p |
| Sub carrier frequency | 6.5MHz |
| Operation temperature | -10 to 40 degrees Celsius |
| Storage temperature | -40 to 80 degrees Celsius |
| Operating humidity | 20 to 80% |
| Storage humidity | 10 to 80% |
| Dimension and weight Excluding SMA connector | 50 x 26 x 13mm, 20g |
| to see the transmitter and camera connections. Note | BNC to RCA adpater is sold separately in accessories. |
Details:, This transmitter is a power house, providing a 1000 miliwatts of pre RF output. It is the best transmitter for long range applications. (for RC models is recommended to install the T1012 as far as possible away from the models receiver) Even with all that power, it weights only around 1oz 30 grams . With all this, and the right setup, for sure you can get video reception miles away. It is highly recommended to install the transmitter in ventilated areas, to allow the air to keep it cool. As any of our transmitters, T1012 has digital Phase-Lock-Loop circuit avoiding frequency drift, providing a stable and solid audio and video delivery. You can not go wrong with it., Features:, , Specifications:, , Standard shipping package:, , Disclaimer:, Hobby Wireless is not responsable any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.,
Click here for Specs 1000mW RF output power Eight (8) ...HobbyWireless
NVG ADAPTER MOUNT
| Model Number | ANVGM-001 |
| Thread Size | standard, 1/4″-20tpi (threads per inch) |
| Construction | polycarbonate |
| Model | ANVGM-001 |
| Shipping Weight | 0.1 |
| Manufactured by | GoPro |
Details:, , Product Description:, , What’s Included:, ,
The NVG Mount conveniently attaches HD HERO cameras to any ...HobbyWireless
8" INCHES LCD-LED MONITOR CUSTOMIZED FOR FPV (SCREEN NEVER GOES BLUE OR BLACK) - OPEN BOX
| Model | EV-8 |
| Screen | 8" inches TFT LCD LED Backlit |
| Dimensions W x H x D | (209 x 147 x 35mm) 8.2" x 5.78" x 1.37" |
| Viewing Angle | 70°/70°(L/R) 40°/50°U/D |
| Contrast Ratio | 500 |
| Weight | < 650 gr (1.35lb) |
| Resolution | 800 x 400 pixels |
| Brightness | 450cd/m2 |
| Audio input | 1 (mono) |
| Input Singal | RCA Video |
| Color System | PAL/NTC/SECAM (manually selected by the user) |
| Operating Voltage | Input 6-18VDC (2s-4s lipo battery can be used) |
| Working Temperature | -20℃～60℃ |
| Storage Temperature | -30℃～70℃ |
| Manufacturer Warranty | 90 days |
Details:, , Specifications:, Video input: 1, Power Consumption: 7W, Includes:, 8" Monitor,
This is an "Open Box" monitor. Customer returned it, it's ...HobbyWireless
DJI 5.8GHZ VIDEO DOWNLINK (TRANSMITTER + RECEIVER)
Details:, , The Wireless Video Link includes both transmitter (TX) and receiver (RX) modules, working in the ISM frequency band of 5.8GHz (5725-5865MHz). Analogue modulated video signals are sent wirelessly by the TX module to the RX module, and then the video signal will be demodulated and sent to a display. There are 8 wireless channels can be selected when you are using this product.These channels are:CH1-5705MHZ, CH2-5685MHZ, CH3-5665MHZ, CH4-5645MHZ, CH5-5885MHZ, CH6-5905MHZ, CH7-5925MHZ, and CH8-5945MHZ., The characteristics of this product are: small size, low power consumption and high sensitivity. The product can be used in many applications requiring wireless video communication. When it's used in the aero-modeling hobby, the Wireless Video Link TX will be mounted to the aircraftand the Wireless Video Link RX is connected to a display screen, allowing video signal wireless transmission,
The new DJI Downlink is specially designed to work with ...HobbyWireless
SPORTBEC SWITCH-MODE BEC
| Input voltage | 9V to 33.6v (3s-8s lithium, up to 21 NiMHs) |
| Output current | 3.5A (~8 standard servos, 4-6 digital) |
| Weight | 13g/.46oz (including wires) |
Details:, , Description:, , Model:, , Specifications:, , Applications:, , Datasheet:,
SportBEC is the higher capacity version of our best-selling ParkBEC ...HobbyWireless
PARKFLYER SWITCH-MODE BEC
| Model | ParkBEC |
| Specifications | Input voltage |
| Output current | 1.25A continuous, 1.5A 60 second peak. (6 4-9g servos, 4 standard servos) |
| Weight | 6.2g/.22oz |
| Weight Without Wires | 4.1g/.14oz |
| Applications | Parkflyers |
Details:, , Description:, The ParkBEC is the smallest and lightest switch-mode BEC on the market. ParkBEC powers your receiver and servos much more efficiently than a standard BEC. As many as six sub-micro servos can be powered without worrying about an overheating BEC. ParkBEC works great up to very high voltages, and is especially suited for running parkflyer type aircraft. ParkBEC is often a necessity at 4s and above., Guide:, How to move between airplanes, Datasheet:, Installation guide.doc,
Many people don't realize that their ESC's BEC rating is ...HobbyWireless
NANO MICROPHONE W/VOLUME CONTROL
| Red | DC Power, 4VDC to 15VDC (connect to your transmitter's red wire) |
| Black (or Brown) | Ground (connect to your transmitter's black wire) |
| White (or Orange) | Audio Out (connect to your transmitter's white wire) |
Details:, If you liked the Tiny-Mic product, the new Mini-Mic should really excite you. It is the same quality adjustable volume, micro-phone as the Tiny-Mic, but is only 1/4 the size and weight, making it the ideal microphone for smaller models where size/weight are issues., Features:, , Wires functions:, , Volume Adjustment:, , Note:, The Nano Mic is NOT reverse polarity protected. Incorrect connections may cause damage and will void the warranty.,
It comes complete with 3-pin Futaba plug, or you can ...HobbyWireless
MINI GSM-GPRS-GPS TRACKER
| - Weight | 44g |
| - Band | 850/ 900/1800/1900Mhz or 900/1800/1900Mhz |
| - GPS Chip | SIRF3 Chip |
| - GPS Sensitivity | -159dBm |
| - Power | 3,7V (bateria li-ion incluida) |
Details:, Here is a powerful FPV device to track down your R/C model in case you lose it., - Size: L:71mm x A:44mm x A:20mm, The package includes:, - GPS / GSM Receiver,
The Tracker has a very sensitive GPS with a built-in ...HobbyWireless
LVBOOST - BOOST CONVERTER
Details:, LVBoost is a boost converter that can take voltages as low as 0.5V and convert them into higher, more useful voltages like 3.3V or 5V. It has an exceptionally low quiescent draw - typically under .4mA. these features make LVBoost a great choice for powering projects from solar or other renewable energy sources., Model:, , Specifications:, , Applications:,
From a 3V input, 500mA @5V out is easily achievable, ...HobbyWireless
ASR-25 - ADJUSTABLE SWITCHING REGULATOR
Details:, The DE-SWADJ 3 is a larger version of our DE-SWADJ adjustable step down voltage regulator. Previously it was necessary to put multiple DE-SWADJ units in parallel to achieve ratings over 1A, which was bulky, expensive and carried with it a considerable increase in dropout voltage. The DE-SWADJ 3 is designed to be stronger, faster and better. It can process 3A of current, typical ripple is 25mV and under ideal circumstances the regulator can be up to 96% efficient., Model:, , Performance:, , Applications:, , Datasheet:,
It continues the ease-of-use of the DE-SWADJ, making it simple ...HobbyWireless
ASR-10 - ADJUSTABLE SWITCHING REGULATOR
Details:, The ASR-10 is the adjustable version of our step down voltage regulators. It is designed to be the easiest possible way to add an adjustable voltage source to a new or existing project with all the efficiency benefits of switch-mode power. The ASR-10 is pin-compatible with the common 78XX family of linear voltage regulators, and has a small screw on top that allows you to change the output voltage as your project evolves. It has integrated decoupling capacitors, so external capacitors are not generally necessary., Model:, , Performance:, , Applications:,
ASR-10 can deliver a maximum of 10 Watts. The screw ...HobbyWireless
MINI RECEIVER VD5M 5 CH/ LED
| Compatibility | ► FrSky modules |
| ► Dimension | 21*16*5.8mm |
| ► Weight | 2.0g / 1.6g (naked) |
| ► Operating Voltage Range | 3.0V-7.2V |
| ► Operating Current | 20mA |
| ► Operating Range | >300M |
Details:, Super small and light weight, the FrSky VD5M is a perfect choice for park flyers and indoor models. It weighs in at only 2 grams!, Specifications:, ► Number of Channels: 5, Features:, ► Super small and light, designed for park flyers and indoor air crafts;,
Additionally, this RX is part of the FrSky "two way ...